Hi all,
I received my i-Pi smarc last week and was wondering if there is an alternative way to power the board, let me explain.
I will use the device in an environment with heavy vibrations, therefore the barrel connector on the board is not the best way forward. I also do not wish to start soldering on the board as this would defeat the quick replace cycle we had in mind.
I noticed the Raspberries we were using previously could be powered by the 40 pin header, is this also the case with the i-Pi ??
By the way, I like the design with modules !, only minor point is the lack of wireless, but i have taken care of that with a USB stick
