Dear @Shawn Doherty, It is possible to power on the targeted device by following the below link. https://www.ipi.wiki/pages/comhpc-docs?page=HowToConfigureBMCMACIPAddress.html 

Dear @O. JUD, USBX_EN_OC indicates "Over Current Protection" for the board. Furthermore, its states cannot be managed.

Is it possible to enable Power On after Power Loss from BIOS?   Version: TianoCore 2.04.100.06.A1 (SYS:.2.06.20220308)

Hi,  I'm wondering what is ports like USB0_EN_OC,USB1_EN_OC,USB2_EN_OC ...  shown in your datasheet (Page 4).  I understand is for power on/off usb port . am i right ?  If ye...

@Jared Jensen NXP didn't support the native Ubuntu image. Acually,   this instruction is using Ubuntu rootfs which is on the top of NXP kernel image and the building logic should work on...

I plan to purchase the I-Pi SMARC IMX8M Plus development kit to get started.  However at some point I would like to try a SMARC module using the i.mx8 QuadMax with 4 Cortex A53 and 2 Cortex A7...

Dear @Dennis Gilmore, Our recommendation is to use: 32GB DDR4 RDIMM 3200 VLP Transcend, TS4GHR72V2EL (29-6AE00-7430) There are also other memories that have been tested and can be used, such as:...

Maybe I have missed I somewhere, I would like to bump the memory to 128GiB, I am trying to figure out what ram modules are compatible so I can get there. I currently have 4x16GiB and would like to ...

Dear @Todd Bonack,      The PX30 supports OTG Mode, and by default the g_serial gadget is loaded, so you need to remove it to load ether. Here are the steps to follow to make PX30 w...

Dear @Todd Bonack,      The IMX8MP supports OTG Mode, and by default the g_serial gadget is loaded, so you need to remove it to load ether. Here are the steps to follow to make i.MX...

Can the OTG on this board be configured as a device side USB? Then by doing a "modprobe g_ether" can it be used as an ethernet connection through "usb0" interface? 

Can the OTG on this board be configured as a device side USB? Then by doing a "modprobe g_ether" can it be used as an ethernet connection through "usb0" interface? 

I changed the password for the admin user for the BMC, I am now unable to login to the BMC, and I have not been able to find docs on how to factory reset the BMC.  how can I reset the BMC?

Dear @ryan permana, Wi-Fi and Bluetooth are not currently available on the I-Pi SMARC Plus Elkhart Lake. Wi-Fi and Bluetooth could be included in upcoming releases.

Dear @Alex Redshaw, The AADP and AVA systems are equipped with the ADATA XPG LEVANTE 240 ARGB CPU Cooler coolers. Click_here for more information. It would be our pleasure to assist you.

Does Elkhart Lake support WIFI and Bluetooth connection?

HELLO, Is the problem solved please? Currently having the same problem. do you have a solution for it? thx

Dear @Alex Redshaw, AVA's BMC does not support Serial-Over-Lan at this time.

Dear @Kaattu Rio, Following the link [click_here] you can find detailed information about accessing the 40-Pin I/O headers on Ekhart Lake for Windows and Linux users.

How to utilize the 40 I/O pin headers on Elkhart Lake through Windows?